PETROSEAL

Application

Foundation Waterproofing Systems in Pakistan

Foundation waterproofing protects structural concrete against ground moisture and hydrostatic pressure. Petroseal uses bitumen membrane systems—typically SBS where flexibility and detailing matter—applied to prepared foundations with continuous coverage at corners, pile caps, and service entries, then protected before backfill. Design must align with the structural engineer’s drainage and waterstop strategy.

Recommended systems

Match site condition to a Petroseal system page.

ConditionRecommended system
New foundation wallsSBS membrane system
High groundwaterDouble-layer SBS
Joints in pourPVC waterstop + membrane continuity

Technical requirements

  • —Compatible primer on concrete
  • —Protection board or screed before backfill
  • —Continuous detailing at changes of plane

Limitations

  • —Cannot compensate for missing site drainage design

Application sequence

  1. Prepare and prime substrate
  2. Install membrane to design height
  3. Seal penetrations
  4. Protect and backfill carefully

Common failure modes

  • —Backfill damage
  • —Discontinuous coverage at corners

Related systems

Related products

  • PetroGrip SBS

    SBS-modified torch membrane—3mm and 4mm with plain, aluminum, or granular surfacing.

  • PVC Waterstoppers

    PVC water-stops for watertight concrete construction joints.

Related projects

Technical downloads

  • PetroGrip SBS Waterproofing Membrane TDS

    Polyester-reinforced SBS-modified torch-applied bitumen membrane — 3 mm nominal thickness, 60/70 bitumen base.

  • PetroDPC Self-Adhesive Bitumen DPC TDS

    Technical data sheet for PetroDPC self-adhesive bitumen damp-proof course rolls — 1.5 mm SBS-modified bitumen on HDPE film, 4.5", 9" and 13" widths, 15 m rolls.

  • PVC Waterstop TDS

    Technical data sheet for Petroseal PVC waterstops — centre-bulb, dumbbell and kicker profiles in 150, 200 and 250 mm widths for watertight concrete joints.

Technical guides

FAQ

Is foundation waterproofing the same as basement waterproofing?
They overlap. Foundation waterproofing focuses on structural contact with soil; basement systems also address occupied below-grade spaces, rafts, and internal finishes.