PETROSEAL

Application

Podium Waterproofing Systems

Podium waterproofing must tolerate structural movement, landscaping loads, and wet–dry cycles while protecting occupied space below. Petroseal uses SBS or APP bitumen systems under protection screeds, or liquid systems where seamless detailing is preferred, with explicit treatment of planters, joints, and drains.

Recommended systems

Match site condition to a Petroseal system page.

ConditionRecommended system
Podium under screed / landscapeSBS membrane under protection
Complex penetrationsLiquid polyurethane system

Technical requirements

  • —Movement joints detailed and sealed
  • —Protection before finishes and planters
  • —Drainage outlets integrated with membrane

Limitations

  • —Landscape irrigation leaks can overload poorly detailed planters

Application sequence

  1. Prepare deck
  2. Install waterproofing
  3. Protect
  4. Build finishes

Common failure modes

  • —Open joints at expansion gaps
  • —Damaged membrane under planter soil

Related systems

  • SBS Waterproofing System

    SBS waterproofing systems use styrene-butadiene-styrene modified bitumen membranes for elasticity and low-temperature fl…

  • APP Waterproofing System

    APP waterproofing systems use atactic-polypropylene modified bitumen membranes with high heat resistance for exposed and…

  • Polyurethane Waterproofing System

    Polyurethane waterproofing systems apply liquid coatings that cure into seamless membranes—useful on complex geometry, d…

Related products

  • PetroGrip SBS

    SBS-modified torch membrane—3mm and 4mm with plain, aluminum, or granular surfacing.

  • PetroGrip APP

    APP-modified torch membrane—2mm to 4mm with plain, aluminum, or granular surfacing.

  • Polyurethane Chemical Coatings

    Seamless liquid waterproofing for roofs, terraces, and industrial floors.

Related projects

Technical downloads

Technical guides

FAQ

APP or SBS for podium decks?
SBS is often preferred under protected podium build-ups for flexibility. APP may be used where the designer specifies it. Confirm with the project specification.